Instructions

In order to make you your own customized grillz the mold of your teeth is required.

Read information carefully before you start

The return postage/label is not included with the package. Customers are responsible for the return shipping. You will receive the mold kit which you should have now and the instruction to do the mold properly are listed below. In this kit you will have enough to make two molds (that means you have two opportunities to do a good impression/mold of your teeth). If you already have a mold and prefer to send us that mold instead of making a new one, you can do so. A dentist can also make the mold for you if you decide to seek a professional. But our easy step by step instructions allows our customers to do the mold themselves and save money doing so.

Step 1

Get the two color putties out of the bag and place them in your hand.

Note: Please wash your hands with soap and dry them before grabbing the putties.

Step 2

Mix the two putties together in a timely manner, kind of like “Play Doh”. Mix until you see them become one solid color. Remember you just have a couple of seconds to mix. You don’t want the puttie to dry so mix as fast as possible.

Step 3

Next, place the mold into the mouth piece and make sure it’s even inside the mouth piece mostly in the front set of your teeth. Do not let the tray over flow. If you going to do only 6 teeth, then place appropriate amount on the tray.

Step 4

Next open your mouth as wide as you can and put the mouth piece in (until your teeth are right in the middle of the mouthpiece without being too close to the walls of the tray) and push straight up (for top grillz) or straight down (for bottom grillz). Bite all the way into the mold. Hold the mouth piece in your mouth for 3-4 minutes (DO NOT MOVE OR TALK). Make sure the mix covers your teeth and that your lips don't get in the way (holding your lip out while biting into the mold). Also your impression must have a good visible gum line (where your teeth meet your gum).

Step 5

After 5 minutes, tilt your mouth piece to the side and pull down GENTLY. Then put the tray that has the impression in the bag that is provided with the order number and send it back to our address.                                                       

 NOTE: If the first mold does not come out good, you can use the other bags to take another impression (the other putties that say extra on them). Please use a marker to write your order number on the mold. Please clearly write your Order Number (if available), your full name, mailing address on the mailing package. Also include the same information and your email address, written in a separate paper, inside the package.

Disclaimer: If the impression did not come out good or if you just need to do a remold you can buy a new molding kit at our website for $25.